Ryoba Saw has two types of blades: coarse-grained “vertical blades” and fine-grained “horizontal blades”. Vertical blades: Cuts along the grain Horizontal blades: Cuts at right angles to the grain Japanese saws are used by pulling. At the beginning of pulling,
Japanese joinery [ERIWA KONE HOZO SASHI]
This is ERIWA KONE HOZO SASHI. This is a joint mainly used for the corner of the base. These combine in this way. On one side, the hozo is on top, The other one is made so that the hoso
Japanese joinery [Shachi Tsugi]that connects the posts.
I will explain “Shachi Tsugi” that connects the posts. Basically, the posts are sandwiched and joined. It is very effective for sandwiching and connecting posts. Of course, it is also possible to connect horizontally as a joinery without sandwiching the
A funahijiki (舟肘木) in Ninnaji~Kyoto Traditional Architecture guide~
A Guide to Kyoto’s Wooden and Traditional Architecture Having been the capital of Japan for more than a thousand years, Kyoto has an embarrassment of riches when it comes to aristocratic architecture, temples and shrines. Each temple or shrine seemingly
Japanese joinery [KANAWA-TSUGI]
I will explain 「KANAWA-TSUGI」. This is a joinery that combines two identical shapes,and The method is very efficient and strong. The feature is that the pegs are used vertically. By hitting a peg the material will be connected. It is
Japanese joinery[Kakushi Kanawa Tsugi]
“Kakushi Kanawa Tsugi” Can be used when connecting short materials. The inside is firmly connected by complicated processing, but the front and bottom (visible part) look straight. At first glance, it looks like a simple connection. It may be Japanese
Japanese joinery [KABUTO-ARI]
「KABUTO-ARI」 The KABUTO is the part that rides on the beam. It means a hat. The ARI part has a wide upper part and a narrow lower part. It is slightly tapered. By doing so, It is possible to insert
Japanese joinery [OKURI ARI]
I will explain OKURI ARI. This is the most difficult level joinery used in suikoushya kyoto school. This supports the sliding door rails. This is a rail, nails cannot be used. Half of it is a dovetail and it’s jointed.
Japanese joinery [Daimochi-tugi]
This is「Daimochi-tugi」 This is a bit different from other joinery. There is always support below this joinery, it is held down by posts. Used under such conditions. This does not stop with a stick but use the dowel rod to
Japanese joinery [OKKAKE-TSUGI]
OKKAKE-TSUGI is a joinery that connects materials in a straight line. After combining, it is completely fixed with pegs, so it is a very durable joinery. It cannot be connected from the side. Since it is a joinery that moves